Choose options
Overview
Two-seat full-spectrum infrared cabin. Three quartz heaters, six carbon panels, and two 660nm/850nm ceiling panels. Plugs into a standard outlet.
At 47.2 inches wide this seats two without either person sitting in front of a heater. Three full-spectrum quartz elements and six ultra low EMF carbon panels share the cabin, with two red and near-infrared ceiling panels so the light reaches both seats rather than one.
Quartz and Carbon Together
Two heater types run in the same cabin. The full-spectrum quartz elements produce near, mid and far infrared across 0.8–23.3 micrometers and come up fast. The ultra low EMF carbon panels behind the back and side slats hold a broad, even far-infrared field once the cabin is warm. Quartz gets you to temperature; carbon keeps the heat uniform rather than concentrated at one wall.
Red and Near-Infrared Overhead
The ceiling panels emit 660nm red and 850nm near-infrared. Running light at the start of a heat session keeps both exposures in one place, with no separate device to position or plug in. The foot panel below is a far-infrared carbon element over tourmaline stones.
Plugs Into a Normal Outlet
This cabin runs on a standard 110–120V household circuit. No dedicated line, no hardwiring and no electrician — which is the practical difference between an infrared cabin and a traditional electric sauna at this size. Installation is tool-free and takes about 20 minutes. The cabin is ready to sweat in 10–12 minutes and reaches 150°F in roughly 20.
Specifications
- Occupancy: 2 persons
- Sauna Type: Full-spectrum infrared — quartz and carbon
- Exterior Dimensions: 47.2" W × 41.3" D × 75" H
- Wattage: 2,000W
- Heaters: 3 full-spectrum quartz
- Carbon Panels: 6 ultra low EMF far infrared — back and sides
- Foot Panel: 1 far-infrared carbon with tourmaline stones
- Ceiling Light Panels: 2 × 660nm red + 850nm near-infrared
- Maximum Temperature: 150°F (66°C)
- Warm-Up: Ready in 10–12 minutes; 150°F in about 20 minutes
- Voltage: 110–120V standard household outlet — no electrician required
- EMF: Less than 2 mG at the seated position
- Wavelength Range: 0.8–23.3 µm (near, mid and far infrared)
- Light Therapy: 660nm red + 850nm near-infrared
- Wood: 100% Canadian hemlock, all-black exterior
- Glass: 0.31 inches (8 mm) tempered, front door
- Interior: No glue — free of VOCs and formaldehyde
- Control: Digital panel for time and temperature
- Connectivity: Wi-Fi with Burneek app; Bluetooth and USB audio
- Lighting: 3 linear ambient LED strips — ceiling, back wall, under seat
- Air: Integrated ionizer and a built-in cabin vent
- Assembly: Tool-free, about 20 minutes
- Certifications: UL, ETL, CE, ISO 9000
- Warranty: 2-year Burneek warranty
- Location: Indoor use only
What Is Included
- Burneek Onyxeek 2-person cabin with integrated heaters and panels
- 3 full-spectrum quartz heaters
- 6 ultra low EMF far-infrared carbon panels
- 1 far-infrared carbon foot panel with tourmaline stones
- 2 ceiling light panels — 660nm red + 850nm near-infrared
- Built-in audio system — Bluetooth and USB
- User manual and setup guide
- 2-year Burneek warranty
Disclaimer
This product is intended for general wellness use only. It is not a medical device and is not intended to diagnose, treat, cure, or prevent any disease or medical condition. Consult a qualified healthcare provider before use if you have a cardiovascular condition, are pregnant, or are managing a chronic illness. Always hydrate adequately before and after sessions.
Two seats, and neither one is in front of a heater
SPECIFICATION
What you are buying.
-
Two full seats
Exterior 47.2" W × 41.3" D × 75" H.
-
Ten heat sources
3 full-spectrum quartz, 6 ultra low EMF carbon panels, 1 tourmaline foot panel.
-
Two ceiling panels
660nm red and 850nm near-infrared over both seats, not one.
-
2,000W, standard outlet
110–120V. No electrician.
-
100% Canadian hemlock
No glue inside the cabin — free of VOCs and formaldehyde.
-
Bluetooth and USB
Built-in speakers, digital control, Wi-Fi with the Burneek app.
HOW A SESSION RUNS
A session, start to finish.
Nothing to plumb, nothing to drain, nothing to schedule around.
Preheat
Set it going and leave the door shut. The cabin is ready to sweat in 10 to 12 minutes and reaches 150°F in about twenty — the quartz elements do the fast work while the carbon panels even the heat out.
Heat
Twenty to thirty minutes is the usual range once you are used to it. Start at 10 to 15. The Onyxeek runs the red and near-infrared ceiling panel at the same time, so the light session is not a separate appointment.
Cool down
Open the door, sit, drink. The cool-down is where most of the cardiovascular adaptation is thought to happen, so it is not the part to rush.
Built as a fixture, run like an appliance
