







Choose options








Overview
Full-body panel at 36 inches. 200 LEDs at 660nm and 850nm, 300W, hangs on a door or mounts to a wall.
Tall enough to cover the whole torso, the legs or the back from one position. Two sessions — front then back — run about twenty minutes in total. It hangs on a door or mounts to a wall, so it needs no floor space.
Two Irradiance Numbers, Both Printed
Mito publishes irradiance measured two ways, and they differ by more than double. A consumer solar meter reads high on an LED array because it is calibrated for broad-spectrum sunlight, not for two narrow bands. A laboratory spectroradiometer is the figure to compare across brands. Both are listed in the specifications below — the lower number is not a weakness, it is the one measured properly.
Specifications
- Coverage: Full body — torso, legs or back in one position
- Dimensions: 36" × 9" × 3"
- Weight: 20 lbs
- LEDs: 200
- Power Draw: 300W
- Irradiance at 6 inches: >70 mW/cm² on a laboratory spectroradiometer (>155 mW/cm² on a consumer meter)
- Wavelengths: 660nm red and 850nm near-infrared, 50/50 split
- Beam Angle: 60 degrees
- Modes: Red only, near-infrared only, or both together
- Timer: Digital, 1 to 20 minutes
- EMF: 0.5–1 mG at close range; background level at usage distance
- LED Lifespan: 50,000+ hours
- Voltage: Compatible with worldwide voltages
- Certifications: FDA Class II registered, ETL listed, ISO 9001/14001, BSCI
- Warranty: 2 years
- Mounting: Door hanging or wall mount — hardware included
What Is Included
- MitoMAX 2.0 panel
- Digital timer control
- Mounting hardware
- Power cord
Disclaimer
This product is intended for general wellness use only. It is not a medical device and is not intended to diagnose, treat, cure, or prevent any disease or medical condition. Consult a qualified healthcare provider before use if you are managing a chronic illness, are pregnant, or are taking photosensitising medication. Do not stare directly into the LEDs.

Full body from one position
SPECIFICATION
What you are buying.
-
200 LEDs, 50/50 split
660nm red and 850nm near-infrared in equal measure.
-
>70 mW/cm² at 6 inches
Laboratory spectroradiometer. Over 155 on a consumer meter.
-
Full body, one position
36" × 9" × 3". Torso, legs or back without repositioning.
-
Door or wall
Hardware included. No floor space required.
-
1 to 20 minutes
Digital. Red only, near-infrared only, or both.
-
Two years
FDA Class II registered, ETL listed, ISO 9001/14001.
HOW A SESSION RUNS
A session, start to finish.
Nothing to plumb, nothing to drain, nothing to schedule around.

Hang it
On a door or mounted to a wall. Hardware is included and it needs no floor space.
Front, then back
Six inches from the panel. About ten minutes a side, twenty in total, on the digital timer.
Choose the band
Red only for surface work, near-infrared for depth, or both together.












